pst(4) [freebsd man page]

PST(4)							   BSD Kernel Interfaces Manual 						    PST(4)

NAME

     pst -- device driver for Promise Supertrak SX6000

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel configuration file:

	   device pst

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   pst_load="YES"

DESCRIPTION

     This driver is for the Promise Supertrak SX6000 ATA hardware RAID controller.  It supports (in hardware) RAID levels 0, 1, 0+1, 3, 5 and JBOD
     on up to 6 ATA disk drives, including automatic rebuild and hotswap, and supports signalling disk status on LEDs on Promise Superswap disk
     enclosures.  The Supertrak line of controllers does not support non-disk devices.

HARDWARE

     The pst driver supports the Promise Supertrak SX6000 ATA hardware RAID controller.

NOTES

     The pst driver does not support manipulating the RAID from the OS, RAIDs need to be set up from the onboard BIOS.	However, hot swap, hot
     spare, and automatic rebuilds are supported without a reboot.

HISTORY

     The pst driver first appeared in FreeBSD 4.7.

AUTHORS

     The pst driver and man page was written by Soren Schmidt <sos@FreeBSD.org>.

BSD
								 December 14, 2004							       BSD

HPTMV(4)						   BSD Kernel Interfaces Manual 						  HPTMV(4)

NAME

     hptmv -- HighPoint RocketRAID 182x device driver

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel configuration file:

	   device hptmv

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   hptmv_load="YES"

DESCRIPTION

     The hptmv driver provides support for HighPoint's RocketRAID 182x based RAID controller.

     These devices support ATA disk drives and provide RAID0 (striping), RAID1 (mirroring), and RAID5 functionality.

HARDWARE

     The hptmv driver supports the following ATA RAID controllers:

     o	 HighPoint's RocketRAID 182x series

NOTES

     The hptmv driver only works on the i386 and amd64 platforms as it requires a binary blob object from the manufacturer which they only supply
     for these platforms.  The hptmv driver does not work on i386 with pae(4) enabled.

SEE ALSO

     kld(4), kldload(8), loader(8)

HISTORY

     The hptmv device driver first appeared in FreeBSD 5.3.

AUTHORS

     The hptmv device driver was written by HighPoint Technologies, Inc., and ported to FreeBSD by Scott Long.	This manual page was written by
     David E. O'Brien.

BUGS

     The hptmv driver does not support manipulating the RAID from the OS, RAIDs need to be set up from the on-board BIOS.

BSD
								 November 17, 2005							       BSD