Today (Saturday) We will make some minor tuning adjustments to MySQL.

You may experience 2 up to 10 seconds "glitch time" when we restart MySQL. We expect to make these adjustments around 1AM Eastern Daylight Saving Time (EDT) US.

Linux and UNIX Man Pages

Linux & Unix Commands - Search Man Pages

FreeBSD 11.0 - man page for if_nve (freebsd section 4)

NVE(4)							   BSD Kernel Interfaces Manual 						    NVE(4)

NAME
nve -- NVIDIA nForce MCP Networking Adapter device driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file: device miibus device nve Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_nve_load="YES"
DESCRIPTION
The nve driver provides support for the NVIDIA nForce MCP and nForce2 MCP2 networking adapter that is embedded in the southbridge of most nForce and nForce2 motherboards. This driver is a reimplementation of the NVIDIA supported Linux nvnet driver and uses the same closed source API library to access the under- lying hardware. There is currently no programming documentation available for this device, and therefore little is known about the internal architecture of the MAC engine itself. The nve driver supports the following media types: autoselect Enable autoselection of the media type and options. 10baseT/UTP Set 10Mbps operation. 100baseTX Set 100Mbps (Fast Ethernet) operation. 1000baseTX Set 1000Mbps (Gigabit Ethernet) operation. The nve driver supports the following media options: full-duplex Set full duplex operation. For more information on configuring this device, see ifconfig(8).
HARDWARE
The nve driver supports the NVIDIA MCP onboard adapters of mainboards with the following chipsets: o nForce o nForce2 o nForce3 o nForce4
DIAGNOSTICS
nve%d: couldn't map memory A fatal initialization error has occurred. nve%d: couldn't map interrupt A fatal initialization error has occurred. nve%d: failed to allocate memory There are not enough mbufs available for allocation. nve%d: device timeout The device has stopped responding to the network, or there is a problem with the network connection (cable).
SEE ALSO
altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), rgephy(4), ifconfig(8)
HISTORY
The nve driver first appeared in FreeBSD 6.0.
AUTHORS
The nve driver was written by Quinton Dolan <q@onthenet.com.au> and David E. O'Brien <obrien@FreeBSD.org>.
BUGS
There are reports that when the card is in auto select mode, ifconfig output reports a 10baseT/UTP output while the LEDs and bandwidth show that the card is actually in 100baseTX mode.
BSD
January 16, 2011 BSD

Featured Tech Videos