debian man page for smp_rep_phy_event

SMP_REP_PHY_EVENT(8)						     SMP_UTILS						      SMP_REP_PHY_EVENT(8)

NAME
       smp_rep_phy_event - invoke REPORT PHY EVENT SMP function

SYNOPSIS
       smp_rep_phy_event [--help] [--hex] [--interface=PARAMS] [--phy=ID] [--raw] [--sa=SAS_ADDR] [--verbose] [--version] [--zero] SMP_DEVICE[,N]

DESCRIPTION
       Sends a SAS Management Protocol (SMP) REPORT PHY EVENT function request to a SMP target. The SMP target is identified by the SMP_DEVICE and
       the SAS_ADDR. Depending on the interface, the SAS_ADDR may be deduced from the SMP_DEVICE. The mpt interface uses SMP_DEVICE to identify  a
       HBA (an SMP initiator) and needs the additional ,N to differentiate between HBAs if there are multiple present.

OPTIONS
       Mandatory arguments to long options are mandatory for short options as well.

       -h, --help
	      output the usage message then exit.

       -H, --hex
	      output the response (less the CRC field) in hexadecimal.

       -I, --interface=PARAMS
	      interface  specific  parameters.	In this case "interface" refers to the path through the operating system to the SMP initiator. See
	      the smp_utils man page for more information.

       -p, --phy=ID
	      phy identifier. ID is a value between 0 and 254. Default is 0.

       -r, --raw
	      send the response (less the CRC field) to stdout in binary. All error messages are sent to stderr.

       -s, --sa=SAS_ADDR
	      specifies the SAS address of the SMP target device. Typically this is an expander. This option may not be needed if  the	SMP_DEVICE
	      has the target's SAS address within it. The SAS_ADDR is in decimal but most SAS addresses are shown in hexadecimal. To give a number
	      in hexadecimal either prefix it with '0x' or put a trailing 'h' on it.

       -v, --verbose
	      increase the verbosity of the output. Can be used multiple times

       -V, --version
	      print the version string and then exit.

NOTES
       Similar information is maintained for SAS SSP target phys (e.g. on a SAS disk). It can be obtained from the Protocol Specific Port log page
       with the sg_logs utility.

       Similar	information  may  be  obtained	for SAS initiator phys (e.g. on a SAS HBA). As an example in Linux 2.6.28 error information can be
       found in this directory /sys/class/sas_phy/phy-4:0 (for the phy 0 in SCSI/SAS host 4).

       Similar information may be obtained for SATA device phys (e.g. on a SATA disk). If there is a SAT layer between OS and the SATA device then
       the sg_sat_phy_event utility can fetch the information.

CONFORMING TO
       The SMP REPORT PHY EVENT function was introduced in SAS-2 .

AUTHORS
       Written by Douglas Gilbert.

REPORTING BUGS
       Report bugs to <dgilbert at interlog dot com>.

COPYRIGHT
       Copyright (C) 2011 Douglas Gilbert
       This  software  is distributed under a FreeBSD license. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PUR-
       POSE.

SEE ALSO
       smp_utils, smp_phy_control, smp_rep_phy_event_list(smp_utils) sg_logs, sg_sat_phy_event(sg3_utils)

smp_utils-0.96							     May 2011						      SMP_REP_PHY_EVENT(8)