CLVMD(8) System Manager's Manual CLVMD(8)
clvmd - cluster LVM daemon
clvmd [-d [<value>] [-C]] [-E <lock uuid>] [-f] [-h] [-I cluster_manager] [-R] [-S] [-t <timeout>] [-T <start timeout>] [-V]
clvmd is the daemon that distributes LVM metadata updates around a cluster. It must be running on all nodes in the cluster and will give
an error if a node in the cluster does not have this daemon running.
Enable debug logging. Value can be 0, 1 or 2.
0 disables debug logging
1 sends debug logs to stderr (implies -f option)
2 sends debug logs to syslog
If -d is specified without a value then 1 is assumed.
-C Only valid if -d is also specified. Tells all clvmds in a cluster to enable/disable debug logging. Without this switch, only the
local clvmd will change its debug level to that given with -d
This does not work correctly if specified on the command-line that starts clvmd. If you want to start clvmd and enable cluster-wide
logging then the command needs to be issued twice, eg:
Pass lock uuid to be reacquired exclusively when clvmd is restarted.
-f Don't fork, run in the foreground.
-h Show help information.
-I cluster manager
Selects the cluster manager to use for locking and internal communications, the available managers will be listed as part of the
clvmd -h output. clvmd will use the first cluster manager that succeeds, and it checks them in the order cman,corosync,openais. As
it is quite possible to have (eg) corosync and cman available on the same system you might have to manually specify this option to
override the search.
-R Tells all the running clvmds in the cluster to reload their device cache and re-read the lvm configuration file. This command should
be run whenever the devices on a cluster system are changed.
-S Tells the running clvmd to exit and reexecute itself, for example at the end of a package upgrade. The new instance is instructed
to reacquire any locks in the same state as they were previously held. (Alternative methods of restarting the daemon have the side
effect of changing exclusive LV locks into shared locks.)
Specifies the timeout for commands to run around the cluster. This should not be so small that commands with many disk updates to do
will fail, so you may need to increase this on systems with very large disk farms. The default is 30 seconds.
Specifies the timeout for clvmd daemon startup. If the daemon does not report that it has started up within this time then the par-
ent command will exit with status of 5. This does NOT mean that clvmd has not started! What it means is that the startup of clvmd
has been delayed for some reason; the most likely cause of this is an inquorate cluster though it could be due to locking latencies
on a cluster with large numbers of logical volumes. If you get the return code of 5 it is usually not necessary to restart clvmd -
it will start as soon as that blockage has cleared. This flag is to allow startup scripts to exit in a timely fashion even if the
cluster is stalled for some reason.
The default is 0 (no timeout) and the value is in seconds. Don't set this too small or you will experience spurious errors. 10 or 20
seconds might be sensible.
This timeout will be ignored if you start clvmd with the -d switch.
-V Display the version of the cluster LVM daemon.
The CLVMD binary to use when clmvd restart is requested. Defaults to /usr/sbin/clvmd.
The LVM2 binary to use. Defaults to /usr/sbin/lvm.
Red Hat Inc LVM TOOLS 2.02.105(2)-RHEL7 (2014-03-26) CLVMD(8)