8 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Hi Guys,
I've wondered for some time the performance analysis between using sed and awk. say i want to print lines from a very large file. For ex say a file with 100,000 records. i want to print the lines 25,000 to 26,000 i can do so by the following commands:
sed -n '25000,26000 p'... (11 Replies)
Discussion started by: Irishboy24
11 Replies
2. Red Hat
Dear Guru,
IHAC who complaint that his CentOS is getting performance issue.
I have to help him out of there.
Could you please tell me which tools is better to gathering the whole system performance data?
-- CPU/Memory/IO(disk & Network)/swap
I would like the tools could be... (6 Replies)
Discussion started by: devyfong
6 Replies
3. HP-UX
Hi all,
Could someone please explain to me how I should read this routing table,
# netstat -rn
Routing tables
Destination Gateway Flags Refs Interface Pmtu
127.0.0.1 127.0.0.1 UH 0 lo0 32808
10.222.47.82 10.222.47.82 UH... (3 Replies)
Discussion started by: rachael
3 Replies
4. Linux
Hello,
how to make entries in routing table perminent (1 Reply)
Discussion started by: teenasuresh
1 Replies
5. IP Networking
Hi all,
I am confusing with routing table, i use linux and iptables.
i have 1 internet gateway, and 1 router for VPN.
here is my network.
eth0=192.168.0.1
eth1=192.168.100.1
192.168.0.0/24 --- eth0(Linux Box)eth1 ---(DSL)---Internet
|
... (4 Replies)
Discussion started by: blesets
4 Replies
6. IP Networking
hi all...
i need to know, where is locate the routing table on sun solaris, how i can saved the configuration....
because when i restart the server, lost the configuration....
thank you...
Regards... (3 Replies)
Discussion started by: chanfle
3 Replies
7. IP Networking
hi all,
how to access ip routing table throgh program,
how should i integrate my rip routing table with the ip routing table :) (0 Replies)
Discussion started by: vinodkumar
0 Replies
8. UNIX for Dummies Questions & Answers
Hi,
I'm trying to connect to a network device, with the connection follwoing the UNIX routing table we set up. Its to go via a specific network Gateway and out throught a specific Lan card (Lan4). However when trying to conenct it keeps going through Lan3 and will not get to its destination.... (3 Replies)
Discussion started by: nhatch
3 Replies