Before they made the change to AUTO duplex, I made the change to FULL on
my side and it drooped the connection
and went to redundant connection,
which was also showing as HALF duplex on their side, my side set to AUTO for
the redundant interface.
So if they were indeed at FULL DUPLEX it would NOT have dropped the
connection and should have been FULL to FULL, but that is not the case.
When I changed back to AUTO it said HALF duplex again on their side. Only
when they changed to AUTO did my side show them as FULL duplex.
Why did my switch say HALF for data center when my switch was set to
AUTO duplex and data center side was set to FULL?
Why would connection drop if supposedly both sides where set to FULL?
This is all very frustrating, the data center is seeing problems on their end
but not disclosing that information to me and suggesting it is my problem.