9 More Discussions You Might Find Interesting
1. Solaris
Hi,
Recently, I had to disable autoneg in one of my servers having ixgbe1 interface. While using below command I got "Permission denied" error:
ndd -set /dev/ixgbe1 adv_autoneg_cap 0
On investigating further I found that adv_autoneg_cap is showing as read-only parameter. Although it is... (1 Reply)
Discussion started by: rochitsharma
1 Replies
2. Solaris
Hello forum,
I have a Solaris 9 Sun Fire v240 server and Sun Fire v440
Recently we made changes and installed a new switch which both of them are connected to it. Cisco Catalyst 3750.
Now the Sun Server v240 is having problems with the network. It was supposed to run at 1000mbs speed.
ndd... (10 Replies)
Discussion started by: br1an
10 Replies
3. Solaris
Following command was set up in startup script on Solaris 8 servers - improved network transfers of files from one server to the another (doubled transfer speed).
ndd -set /dev/tcp tcp_host_param '10.140.20.10 sendspace 279600 recvspace 279600 timestamp 1'
Now they are getting a new server... (15 Replies)
Discussion started by: RTM
15 Replies
4. UNIX for Advanced & Expert Users
I have a T2000 server which has 4 e1000g NIC cards
How do I configure each of it for 1Gbit full duplex and turnoff autonegotiation.
Please assist
Thanks (4 Replies)
Discussion started by: Tirmazi
4 Replies
5. Solaris
Solaris 10 server (SunOS 5.10 Generic_137137_09)
I have a services file configured in /etc in there windows clients connect to my server on port 6034-6037
when I do the following
netstat | grep TestServices
it pulls all the connections active for those ports
so right now I have 10 clients... (3 Replies)
Discussion started by: deaconf19
3 Replies
6. Solaris
Hi,
I would like to know whether there is any config file that i can refer to for the result of 'ndd -get /dev/tcp tcp_time_wait_interval'?
When i man 'ndd', there is one statement which is -> Each driver chooses which parameters to make visible using ndd. Does it answering my question above... (3 Replies)
Discussion started by: honmin
3 Replies
7. Programming
Hi,
Is there any function calls available ( for using in a C program ) to get the Ethernet Link status. ?
I am looking for the status available from
ndd /dev/hme link_status
And how about plumbing and configuring an interface using C program ?
BTW, Is all this documented... (3 Replies)
Discussion started by: shibz
3 Replies
8. Solaris
Hello Gurus
I would like to know more about ndd commands related to ethernet(NIC) like how to set link_status, link_speed & link_mode as I know how to check these value. And I also would like to know how to make these setting permanents after reboot as I know that these setting will vanish... (5 Replies)
Discussion started by: amity
5 Replies
9. Solaris
Hi Guys,
I need help with ndd.
I was going through network FAQ but i have more questions then answers regarding ndd.
#ndd -set /dev/hme instance 0
#ndd -set /dev/hme adv_100fdx_cap 1
#ndd -set /dev/hme adv_100hdx_cap 0
#ndd -set /dev/hme adv_10fdx_cap 0
#ndd -set /dev/hme adv_10hdx_cap 0... (2 Replies)
Discussion started by: nitinkgoud
2 Replies