10 More Discussions You Might Find Interesting
1. IP Networking
Actually a very basic question this one. I've got a Solaris 10 x86 server box on a network. There are a group of other servers I need to connect to from it, but via a VPN connection. If I install a vpn client on my solaris box, can I configure the VPN connection so it only routes certain... (1 Reply)
Discussion started by: mikecouk
I have installed two solaris boxes in an VM.
First box is 10-1
Has two interfaces and in connected briged to the lan an d connected internal to an virtual lan.
Second box is 10-2
Has one interface.
Now what I wanted to do is a setup so that 10-2 connects through 10-1 to the lan.... (3 Replies)
Discussion started by: jld
e1000g0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 10.13.157.127 netmask ffffffc0 broadcast 10.135.151.191
e1000g1: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 8
inet 10.13.157.227 netmask ffffffc0... (3 Replies)
Discussion started by: sunnybee
4. IP Networking
Right, i need to admit Im c4p on networking. I hate it, always have, always will. Here's my problem
Ive got 3 hosts. A B and C. I need to directly contact host C from host A, but at the moment I have to ssh on to B, to then ssh on to C.
so, I need to set up host b, to forward... (3 Replies)
Discussion started by: sbk1972
I have just installed Solaris 10 for x86. The install seemed to have worked fine, and I have configured my hostname and am able to login and do whatever. However, networking does not seem to have been installed. I have a router which assigns ip address via DHCP. I would have thought Solaris would... (5 Replies)
Discussion started by: Phobos
6. IP Networking
how do i make sure that the new routing should take effect on the os memory right away? what should i run after i add all the new "route add ....".
I have an example below:
bash-2.03# netstat -rn
Routing Table: IPv4
Destination Gateway Flags Ref Use Interface... (1 Reply)
Discussion started by: itik
may i know what is the command for configure
new ip, subnet mask and gateway ??
thanks .. (3 Replies)
Discussion started by: Farbegas
8. UNIX for Dummies Questions & Answers
I am trying to configure an ip address, netmask, and default gateway on my solaris machine. For example, in Linux I would do the following command:
#ifconfig eth0 xx.xx.xx.xx netmask 255.0.0.0
#add route or route add default xxx.xxx.xxx.xxx
In Solaris 10, I believe the commands are... (7 Replies)
Discussion started by: annointed3
9. UNIX for Advanced & Expert Users
What's the idea of Unsyncron SUN WS's ? one of our client had a problem & my supervisor told me that this causes of unsynchron WS's i mean maybe the setting of one is not compatible with other .....
Any Suggestion would be helpful
nikk (1 Reply)
Discussion started by: nikk
10. Filesystems, Disks and Memory
i would like about the emulation in workstations. thanks. (2 Replies)
Discussion started by: rmilano