7 More Discussions You Might Find Interesting
1. IP Networking
I need this as soon as possible to solve it or at least to find out what is the problem.
I have configured IPSec tunnels with Openswan and Cisco ASA, i have established a connection and the ping was fine, but after some time there is request time out from both sites. I don't have ASA... (0 Replies)
Discussion started by: ivancd
2. IP Networking
I try to connect 2 LANs with IPSec/Openswan
LAN 1: 192.168.0.0/24
LAN 2: 192.168.1.0/24
This is my Config:
conn HomeVPN # # Left security gateway, subnet behind it, nexthop toward right. left=192.168.1.29 ... (1 Reply)
Discussion started by: bahnhasser83
3. IP Networking
Hi,I want connect my ASA 5510 firewall to a 3750 switch with RIP routing. Unfortunately,I am having issues passing the VPN subnet through rip to the 3750.I don't understand how the routing table is populated on the ASA. Any suggestions? (0 Replies)
Discussion started by: Ayaerlee
4. IP Networking
Q: "Does Cisco 1921 router support,, act as an endpoint for, site to site VPNs using IPSec? If so, how many? "
A: If you get the Cisco 1921/k9 with the security services bundle then it will have built in security features. Cisco, typically includes IP Sec tunnels I believe as part of that... (0 Replies)
Discussion started by: Ayaerlee
5. IP Networking
Setup a site to site VPN between two cisco routers.
One of the site locations is unable to access ports such as https://example.com:9001
How do I let them go into port 9001?
They can ssh, ftp, telnet and everything else.
Is this a VPN issue or ACL access issue?
permit ip host... (0 Replies)
Discussion started by: photon
6. What is on Your Mind?
Check out this site. This will be helpful for all.
Link removed. (3 Replies)
Discussion started by: jadebellant
7. UNIX for Advanced & Expert Users
IŽd like to have some opinions of waht settings we should take note before power down a server and move it to other facilities. Of course, the first thing is check the backups.
Thanks in advance. (1 Reply)
Discussion started by: spacewalker
ASA(1) BSD General Commands Manual ASA(1)
asa -- interpret carriage-control characters
asa [file ...]
The asa utility reads files sequentially, mapping FORTRAN carriage-control characters to line-printer control sequences, and writes them to
the standard output.
The first character of each line is interpreted as a carriage-control character. The following characters are interpreted as follows:
<space> Output the rest of the line without change.
0 Output a <newline> character before printing the rest of the line.
1 Output a <formfeed> character before printing the rest of the line.
+ The trailing <newline> of the previous line is replaced by a <carriage-return> before printing the rest of the line.
Lines beginning with characters other than the above are treated as if they begin with <space>.
The asa utility exit 0 on success, and >0 if an error occurs.
To view a file containing the output of a FORTRAN program:
To format the output of a FORTRAN program and redirect it to a line-printer:
a.out | asa | lpr
The asa utility conforms to IEEE Std 1003.2-1992 (``POSIX.2'') and to X/Open Commands and Utilities Issue 5 (``XCU5'').
J.T. Conklin, Winning Strategies, Inc.
September 23, 1993 BSD