9 More Discussions You Might Find Interesting
1. UNIX for Advanced & Expert Users
Dear all,
I have a remote CentOS7 server that has two network cards. Each card has four ports and port one of card one was defined with the IP address assigned to the server. So far, so good and it's been working for over a year. We have now got cables sorted out so there are four paths... (4 Replies)
Discussion started by: rbatte1
4 Replies
2. Linux
Hello Admins,
My ask is how can I add two different subnet IPs to same box with two different gateways?
The issue is I can connect to the box when I am on ethernet LAN, but I am not able to connect to the same IP when I am on wifi. The server is RHEL 7 VM on vmware.
How can I get connected... (4 Replies)
Discussion started by: snchaudhari2
4 Replies
3. Red Hat
Dear All
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
Discussion started by: nnnnnnine
0 Replies
4. IP Networking
I am new in squid proxy.
My question is how to (and if it's necessary) to set one NIC for inbound traffic (http requests) and one NIC for outbound traffic (http answers)?
Thank you in advance! (4 Replies)
Discussion started by: aixlover
4 Replies
5. Solaris
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Discussion started by: vectrum
0 Replies
6. Programming
Dear Mates,
I am trying to write a macro to replace with its arguments with singles quotes around each argument.
#define DECR(a,b,c,d,e) decr('a','b','c','d','e')
if the usage is
DECR(k,e,y,s,\0)
I want it to be replaced with the following
decr('k','e','y','s','\0')
However it... (2 Replies)
Discussion started by: tamil.pamaran
2 Replies
7. SCO
hi
I have SCO 5.0.6 and if I type Ctrl-D, the system will NOT enter single user mode, it goes into multi-user mode.
If I use the init 1 command, I get right back into the cycle ... an I'm at the Ctrl-D prompt again. (2 Replies)
Discussion started by: ccc
2 Replies
8. Shell Programming and Scripting
Hi,
I have a script which generates a log file on demand by redirecting the output to a log file. But the requirement is :
echo A
echo B
echo C
should print A B C
not like
A
B
C
and this has to be handled in script only..not in the shell level (while running the script only) .... (5 Replies)
Discussion started by: bhaskar_m
5 Replies
9. IP Networking
I have a SCO OpenServer 5.0.5 and my cuestion is can i have 2 ip address in one nic?, how?.
Thanks. (1 Reply)
Discussion started by: dvl
1 Replies