10 More Discussions You Might Find Interesting
1. Red Hat
I was testing Networking Teaming (activebackup) with a VM hosted on VmWare Workstation and VirtualBox, and the result is, if the active interface is down, the system is not using the backup interface.
Tested on both CentOS / RHEL 7
Please find below the command I have used to configure teaming.... (0 Replies)
Discussion started by: atanubanerji
0 Replies
2. IP Networking
Could someone tell me how to setup VPN for RHEL5 so that i can connect remotely from another location. (1 Reply)
Discussion started by: kartheekm56
1 Replies
3. Red Hat
Hi,
I am trying to set up a wireless internet connection on my centos OS (6). I can connect via the copper using the internal LAN but cannot get the wireless connection working.
The 2 files that I have configured are:
My wpa_supplicant.conf:
ctrl_interface=/var/run/wpa_supplicant... (1 Reply)
Discussion started by: Duffs22
1 Replies
4. Red Hat
Hi, I face up a terrible problem that is for me setting up kdb or any other kernel debugger.
Little background:
I am writing linux kernel driver in C and ASM on host (real) machine that is Linux RHEL 6.0.
I run (I mean debug using printk's) that driver on virtual machine: QEMU, RHEL 6.0 (v... (1 Reply)
Discussion started by: Chrisdot
1 Replies
5. Linux
Hello everyone,
I have question how i can setup local ipv6 network ? Here is my network:
I have main ipv6 gw and server X for example that is connected with my main ipv6 gw and all ping6, traceroute6 is working. My local network is connected to one switch and main ipv4 gateway is that server X... (2 Replies)
Discussion started by: gild
2 Replies
6. Linux
I'm trying to set up a system where I have a front end machine that has a list of proxies it knows to connect through, and all the machines in the office route through this front end machine to go through the appropriate proxy IP.
Could someone point me in the direction of some software... (0 Replies)
Discussion started by: kettlewell
0 Replies
7. Solaris
hi,
i have sunfire 280r sparc. i would like to know how to setup interface with command ndd line and put it in the file permanently.
my card is eri0 and speed can be 100mb or 1000mb full duplex.
thanks in advance. (3 Replies)
Discussion started by: lamoul
3 Replies
8. IP Networking
Hello everybody,
I am a new unix user (Solaris 10). I was wondering if anybody can help me figure out how to connect to the network in my work place. I know my IP address, subnet mask, gateway, primary and secondary DNS addresses but I don't know how to enter these settings into my Solaris.
... (3 Replies)
Discussion started by: arash05
3 Replies
9. Solaris
on sparc solairs 2.8 which files i need to configure for network setup:
/etc/hosts
/etc/defaultrouter
/etc/netmasks
/et/resolv.conf
what els?.
by the way, how do i configure for rsh?.
like for doing "rsh remotehostname date"?. (2 Replies)
Discussion started by: S26+
2 Replies
10. IP Networking
I am moving a SUN 250 server from one location to another. The IP address has to change in order to make the server visible in the new building. The system administrator has given me the new IP address for the server, the DNS server IP and the default gateway IP. First question, is this all the... (2 Replies)
Discussion started by: pkappaz
2 Replies