8 More Discussions You Might Find Interesting
1. HP-UX
Hi,
Unable to make tape backup, please help.
/opt/ignite/bin/make_tape_recovery -a /dev/rmt/?mn -I -v -m tar -x inc_entire=vg00
* Creating local directories for configuration files and archive.
======= 04/25/16 16:28:08 IST Started /opt/ignite/bin/make_tape_recovery.
(Mon... (4 Replies)
Discussion started by: anuragr
4 Replies
2. Red Hat
Hi All,
Could anyone please help to resolve the below problem.
I installed RHEL5.5 in my desktop.But when i try to activate the ethernet connection then it gives me the error.
I spent 2 days for the above and go through with several suggestion found by googling. But no luck.
... (0 Replies)
Discussion started by: Tanmoy
0 Replies
3. Shell Programming and Scripting
Hello all,
Here is the explanation of my problem:
I have a cronjob that connects to a NAS to do backups from my laptop to this NAS device.
The script that I wrote does check if there is a host (the NAS) responding on 192.168.1.10 and tries to connect to it with the following command:
mount -v... (3 Replies)
Discussion started by: freddie50
3 Replies
4. Shell Programming and Scripting
HI all, im new to shell scripting. need your guidence for my script. i wrote one script and is attached here
Im explaining the requirement of script.
AIM: Shell script to run automatically as per scheduled and backup few network devices configurations. Script will contain a set of commands... (4 Replies)
Discussion started by: saichand1985
4 Replies
5. IP Networking
Hey foks
my problem looks like this:
Computer 1 has two network interfaces (A and B). It's connected to computer 2 via ssh using network interface A. kann I forward network interface B to computer 2, so it shows up for example in ifconfig on computer 2? how? should i use something else than... (1 Reply)
Discussion started by: smf15
1 Replies
6. Red Hat
How to monitor network device traffic using MRTG?
How can I add network devices in MRTG configuration to monitor? (2 Replies)
Discussion started by: manalisharmabe
2 Replies
7. UNIX for Dummies Questions & Answers
Good morning!
Why would having a fake network device be useful?
Thanks in advance
Bigben (0 Replies)
Discussion started by: bigben1220
0 Replies
8. Programming
HI,
I am writing a network device driver for RTL8139c card on 2.6.18 kernel ... I am facing few queries listed below
1. Can i able to at all write a driver for RTL8139C or Realtek had designed new chip for 2.6 series kernel?
2. If no then which driver file 2.6.18 uses .. Is it 8139too.c or... (1 Reply)
Discussion started by: niketan
1 Replies
