9 More Discussions You Might Find Interesting
1. Solaris
What command can I use to find out details about a netapp filer.
I have a directory that is a filer i would like to know details about the source host/folder that it points to.
Thanks. (2 Replies)
Discussion started by: jjohnson
2 Replies
2. AIX
Hi,
I have aix 6.1 box. I want to configure iscsi luns from netapp storage. I tried in google but not getting proper solution for that. i m not getting the proper iqn name.
Please share me the steps to complete this requirements.
Thanks in advance. (1 Reply)
Discussion started by: sunnybee
1 Replies
3. UNIX for Advanced & Expert Users
we have a v440 SUN machine with a NetApp FAS3140 SAN storage, the v440 got 2 HBA qlogic cards both connected to the switch side in NetApp 3140, zoning in netapp configured proberly and luns are adversitesed to the SUN machine, the problem i am facing is that when i try to configure the mpxio i am... (7 Replies)
Discussion started by: q8devilish
7 Replies
4. Filesystems, Disks and Memory
Hi Folks!
I'm new in using NFSv4 and do have a little trouble. I had a partition working with NFSv3, at the beginning i couldn't see on the client the German umlauts letters {ö,ä,ü} a manipulation of the LANG environment variable helped and the filenames with this letters were shown normally... (2 Replies)
Discussion started by: oku
2 Replies
5. Filesystems, Disks and Memory
Hi All,
What will exactly happen? if I run "quota off" and "quota on" after removing qtree in a netapp
Due to this any slowness/quota changes will occur for any other qtrees?
Thanks (3 Replies)
Discussion started by: Tlogine
3 Replies
6. Solaris
Hi,
I've just edited this post. I found the solution for this. Thanks. (0 Replies)
Discussion started by: gwhelan
0 Replies
7. Cybersecurity
Hi all
Background
some of the users shuold have access to a folder on the netapp
and for other users the access should be denied
Question
How can I doing that ?
Thanks at advance
Sam (3 Replies)
Discussion started by: skfn1203
3 Replies
8. Solaris
I have this problem when i integrate a new san switch in DFM 3.01 R1 :
dfm fcswitch add switchname1
Error: Host switchname2 (11197) already exists.
switchname2 is a similar san switch but in another fabric, switchname2 is already integrated in DFM database.
Bests Regards
Olivier (2 Replies)
Discussion started by: omainfroy
2 Replies
9. Filesystems, Disks and Memory
I have been trying to backup my NetApp /vol/vol0 data to local tape drive. It is around 68GB.
The tape I am using is DLT tape and should be able to handle 70GB data. However, dump always
aborted around reaching 57~58GB data.
Tape drive is attached on NetApp.
1st try to dump /vol/vol0 to... (2 Replies)
Discussion started by: yellowfish
2 Replies