8 More Discussions You Might Find Interesting
1. Linux
Hello Admins,
My ask is how can I add two different subnet IPs to same box with two different gateways?
The issue is I can connect to the box when I am on ethernet LAN, but I am not able to connect to the same IP when I am on wifi. The server is RHEL 7 VM on vmware.
How can I get connected... (4 Replies)
Discussion started by: snchaudhari2
4 Replies
2. Red Hat
Dear All
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
Discussion started by: nnnnnnine
0 Replies
3. IP Networking
I am new in squid proxy.
My question is how to (and if it's necessary) to set one NIC for inbound traffic (http requests) and one NIC for outbound traffic (http answers)?
Thank you in advance! (4 Replies)
Discussion started by: aixlover
4 Replies
4. Solaris
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Discussion started by: vectrum
0 Replies
5. UNIX for Dummies Questions & Answers
In my company ,there is a mail server that services approximately 3,000 users. 2,000 users access their email via a POP-3 service, while the remaining 1,000 users access their email via a Unix mail reader. Recently users have complained about speed of disk access, so a new 10 gigabyte
disk has... (1 Reply)
Discussion started by: lemon_06
1 Replies
6. SCO
hi
I have a fresh installation of SCO 5.0.6 and I have download a NIC driver for Intel Pro 1000:
ftp://ftp.sco.com/pub/openserver5/507/drivers/eeG_5.0.7g/VOL.000.000
Howto install it using floppy?
---------- Post updated at 04:02 PM ---------- Previous update was at 02:18 PM... (0 Replies)
Discussion started by: ccc
0 Replies
7. Red Hat
Hello,
I'm extremely new to Linux. I've been a windows admin for years stupid me, should have got into Linux way back. So now playing catch up. I was hoping someone could help me get started. I've been online reading but getting confused a lot of info and very different from windows.
I... (0 Replies)
Discussion started by: kidsusuki
0 Replies
8. Shell Programming and Scripting
Guy's
I need help calculating a list of numbers that will be majority Terabytes but also have Gigabytes intermingled. So far when I calculate this, the Gigabytes throw off my true Terabyte total. Here is a list……
total 1.56 TB ,Mon Jun 09 23:59:11 2008
total 3.42 TB ,Tue Jun 10 23:59:10 2008... (3 Replies)
Discussion started by: terryporter51
3 Replies