10 More Discussions You Might Find Interesting
I need to extend a soft partition from 20G to 100G. New disk is already added as a meta device. This soft partition is already assigned to a guest LDOM. Can someone let me know the steps to increase soft partition so guest LDOM can recognize the new space.
Thanks (1 Reply)
Discussion started by: Gho
2. Red Hat
I have a Red Hat Linux 5.9 Server installed with one hard disk & 2 Partitions created on it as follows,
/boot - Linux Partition & another is
LVM - One VG & under that 5-6 Logical volumes(var,opt,home etc).
Here my requirement is to take out 1GB of space from LVM ( Any logical... (5 Replies)
Discussion started by: gr8_usk
while formatting hard disk i am getting following error.
Partition 1 ends at 266338338
It must be between 34 and 143374704.
label error: EFI Labels do not support overlapping partitions
Partition 8 overlaps partition 1.
Warning: error writing EFI.
I have formatted the... (2 Replies)
Discussion started by: nikhil kasar
is there any possibility how to rename soft partitions??
Here I found that this is not possible (I know that it is) but I need do it in some supported way.
This is production system it is why I need do it... (0 Replies)
Discussion started by: brusell
The following is the summarry:-
1) Four disks in server ie (c1t0d0. c1t1d0, c1t2d0, c1t3d0). c1t2d0 is the disk to be replaced.
c1t0d0 and c1t2d0 are mirrors.
c1t1d0 and c1t3d0 are mirrors.
Metadb to be deleted is in c1t2d0s7
a) Mirror d35 has 2 submirrors d38 and d39
d38 is a stripe... (0 Replies)
Discussion started by: aji1729
Am trying to expand the soft partition which is in mirror. Am getting following error. Whether is it possible? or i am doing wrongly. Please assist.
bash-2.05# metastat d100
Submirror 0: d102
Submirror 1: d105
... (7 Replies)
Discussion started by: gowthamakanthan
Not sure why solaris couldn't detect the geometry of a hard disk which has a working OS of winxp pro.
Is it due to the different OS that the partition information is stored in different location?
When I type '"format" it is shown as below,
c3d1 < drive type unknown>... (5 Replies)
Discussion started by: just.srad
8. UNIX for Advanced & Expert Users
Currently I am working in One of the webhosting company and I found
on one of my server "/home" partition is getting full say 105% usage...
But when I actually check the partition size using "du -h", exact partition
utilization is only 60-70%.
So... (1 Reply)
Discussion started by: jagdish.machhi@
9. UNIX for Dummies Questions & Answers
I've created a partition with GNU Parted, how do I mount the partition?
The manual information at http://www.gnu.org/software/parted/manual/parted.html is good, but I am sure about how I mount the partition afterwards.
--Todd (1 Reply)
Discussion started by: jtp51
10. UNIX for Dummies Questions & Answers
I am new to Linux so hope some one could help me here.
I have a 30 Gb HD and windows Xp is my O/S, HD is not partitioned,but I want to Partitioned it, so I could Install Knoppix(Linux)on one of the partitioned one, how could I do this? OR should I erase every thing and then... (1 Reply)
Discussion started by: amir