10 More Discussions You Might Find Interesting
I run lubuntu from usb (try lubuntu, it's not install on my pc )
And i try to connect to network
I see the network name
And i put the pass
But it's not connect..
I tried to open hot spot on my phone and try to connect and it's not connect
I have edumax n150
Try to install new driver -... (0 Replies)
Discussion started by: popcoern
I am a new to Ubuntu linux and trying to learn it. I am using ubuntu 10.04. I am getting problem in setting my wireless network. I set it up properly and was working fine. But suddenly it stopped working, though the wireless icon saying that it is connected, but can't load any page. I... (2 Replies)
Discussion started by: linux_learner
3. IP Networking
I have a Realtek 8139 interface in one of my machines and it will not connect to the network. /etc/rc.conf contains ifconfig_rl0="DHCP" and "rl0" was obtained from a dmesg. A network interface restart yields the following:
# /etc/rc.d/netif restart
Stopping network: lo0 rl0 fwe0 plip0.
rl0: no... (3 Replies)
Discussion started by: figaro
Is it possible to setup wireless internet network with Unix? if its possible pls tell me how. (6 Replies)
Discussion started by: mutiat
hello , i setup a lan network , but i don't know how configure master and slave in the lan network please help me:confused: (2 Replies)
Discussion started by: hossein
6. UNIX for Dummies Questions & Answers
Hi , all
I have the same problem as posted by stakes20 , but i could not find these drivers (4 Replies)
Discussion started by: ibasit
My wlan is working fine if theres no encryption. But as soon as i activate encryption, netcardconfig doesn't work trying to get dhcp...
iwconfig says that there is an access point (shows the mac address)
what could be the Problem? (0 Replies)
Discussion started by: jrosset
i have a RealTek Lan Card on my machine. Does Solaris 9 supports this lan card .
Shafi (3 Replies)
Discussion started by: sol8admin
9. IP Networking
I have a laptop with a Linksys Wireless G PCMCIA card and a cable connection goin into a router and then a patch lead from the router going to a Linksys Wireless G access point IP 192.168.1.245 with DHCP disabled.
I can connect to the access point from the laptop, but how do I get the... (1 Reply)
Discussion started by: perleo
At the moment, I have three computers at home. I want to use boardband for my three computers. But I don't want to use network at home. I have been looking for a product which call OriNoCo USB Cilent. How do I connect to the internet with my computer??
If I post this in a wrong place, please... (0 Replies)
Discussion started by: him