Hi All,
I am new to Unix and have a simple question. I would like to do three sed replacements in a large text file. The command I am using is as follows....
sed –n –e ‘s/:A/:X/’ –e ‘s/:B/:Y/’ –e ‘s/:C/:Z/’ myfile.txt > myfile_SED.txt
The : need to be the search to identify specific :A, :B,... (3 Replies)
Hi all,
I have application running on sun server T5440 4x8x1.4 GHz, 64 GB RAM, application running very slow though load average too low. when I install my application on another server SUN M3000 (One CPU 1x8x2.5GHz, 8GB RAM), application run smoothly.
Here is my server T5440 info:
... (6 Replies)
Hi,
Recently i came across a disk that seems to be faulty and need help. I have gathered some information by running below commands and any help on how to solve this will be great.
# uname –a
SunOS XYZ 5.7 Generic_106541-16 sun4u sparc SUNW,Ultra-4
#df -k
Filesystem kbytes used... (3 Replies)
is there a version of anything linux distro that could clone/emulate sco close enough to run the 1 software program we keep this server for ?
boil this question down some
if a program is running on a sco system now are there any alternatives ? (2 Replies)
Hi,
I've updated a few M3000s to new firmware without any hassle, but on one of them the following is happening:
XSCF> getflashimage -u wayner ftp://10.16.122.200/tftpboot/IKXCP1102.tar.gz
Error: insufficient free space
Any idea how to delete whatever old firmware is on there so I can... (7 Replies)
Hi,
We are planning to buy new server for our data center. Sun T5240 or M3000 which one have better performance, we are going to create many dt sessions in this server. So, i need your suggestions.
RJS (4 Replies)
Dear Sun gurus,
I have Sun Fire V240 server with its StorEdge 3300 disk-array. Following are its disks appeared in format command. I have prepared its partitions thru format and metainit & metattach (may be i have made wrong steps, causing the errors below because I have done thru some document... (1 Reply)
i have unix box , which currently has 2 scsi disk , as shown by format command, one at target 1 and another at target3 (which is current boot disk).
can i use both the disk , if so will df -k show usage of both ?
can any one guide me how to span file system across multiple disk. i m using sun 5.7... (4 Replies)