9 More Discussions You Might Find Interesting
1. Red Hat
There are two servers which needs to be connected via the port number 1521 from a remote server.
This is the port config in the first server : L28tstream1 :
# netstat -tulpn | grep 1521
tcp 0 0 10.67.26.183:1521 0.0.0.0:* LISTEN ... (2 Replies)
Discussion started by: anaigini45
2. IP Networking
I have read some forum theads about the open and close ports. some points are clear and it is not working on my machine or something am i missing?
I have commented out a port /etc/services, one application uses
then when i use the telnet <hostname> <port_blocked> it shows connected..... (1 Reply)
Discussion started by: balamv
3. UNIX for Dummies Questions & Answers
just a quick question:
a. whats the simplest command to check open port and the corresponding services?
bash-2.05# netstat -an | grep LISTEN
*.199 *.* 0 0 49152 0 LISTEN
*.8989 *.* 0 0 49152 ... (1 Reply)
Discussion started by: lhareigh890
may i know the exact steps to open a port in solaris.i have some rough idea - which is adding the port number in /etc/services.
but i am not sure the correct conventions, steps or any other steps.
kindly advise.thanks guys ! (1 Reply)
Discussion started by: cromohawk
I have a number of Solaris 8 Sun servers that have open ports that I cannot identify. I see some with 1013-1023 (which are reserved ports according to the IANA. Lsof does not identify these. I rebooted the server and they went off, but this morning I saw they were all back on again. Any... (1 Reply)
Discussion started by: csgonan
6. UNIX for Dummies Questions & Answers
I have a number of Solaris 8 Sun servers that have open ports that I cannot identify. I see some with 1012-1020 (which are reserved ports according to the IANA. Lsof does not identify these. One server has all these on and one server just has 1017.
*.1023 ... (3 Replies)
Discussion started by: csross
7. UNIX for Advanced & Expert Users
1) how to determine available ports in a box (solaris)
do i have to go for a netstat on all the ports?
2) how to block a particular port for a particular type of connection.
Any help would be greatly appreciated
Thanks (7 Replies)
Discussion started by: matrixmadhan
how can i open ports i need in red hat server vs root access ? (7 Replies)
Discussion started by: Sirius
/* Linux Slackware */
Nmap shows the following ports open on the gateway.
i would like to close as... (10 Replies)
Discussion started by: LowOrderBit