Hey than alot! It is working fine. is it possible to continue the flow 191:391-391-591....?means if it didnt find any thing it should print 0 like [a1 391 591 0].
sometimes in Solaris 8 when I go to mount filesystems using either the mount command or by editing the /etc/vfstab, i get a nice little error message saying the the number of allowable mount points has been exceeded. I have read man pages until I am blue in the face and no where can I find what the... (3 Replies)
I have a simple gnuplot question. I have a set of points (list of x,y,z values; irregularly spaced, i.e. no grid) that I want to plot. I want the plot to look like this:
- points in map view (no 3D view)
- color of each point should depend on its z-value.
- I want to define my own color scale
-... (0 Replies)
Hi,
I am trying to write a script to get entries between two points lets say start and end points from a log file,
the log file time format is as follows
Start - 07/Aug/2008:18:26:43
End - 07/Aug/2008:19:36:43
I tried using the following awk command but it couldnt pick up the entries... (3 Replies)
hi,
I believe a mount point does not have to be a physical disk, but rather a logical one? Is this correct? if so, how can I find out if my mount points are on different physical disks?
thanks (9 Replies)
Discussion started by: JamesByars
9 Replies
5. Post Here to Contact Site Administrators and Moderators
Hi folks,
I have been asked to performed the following:
Add the following new moint points systemA:/avp and SystemB:/usr/sap/trans to be the new linux server ZZZ
How can I add those mount points and how those mount points can become another linuz server?:wall::wall::wall: (2 Replies)
I have 2 physical interfaces (bnx0 and bnx1) aggregated into aggr1. I need to assign second IP, and normally I know how to do it to physical interface (i.e. bnx0:1) however same trick (aggr1:1) is not working. Is there any way to do it? (0 Replies)
Hi all,
I need to run a bunch of commands seperated by ; but then count the total lines of output. Pipes and redirection don't seem to be helping me. Anyone know how I can do this properly:
ls /usr/bin/nslookup ; ls /usr/sbin/lsof ; ls /sbin/ifconfig ; ls /usr/sbin/dmidecode ; ls... (2 Replies)
Hi,
I have a AIX5.3 P6-520 with 8x1Gb Ethernet ports with possible connections to 2 CISCO 2960 switches.
I can create 8023ad Etherchannels which work correctly with the switches (I have set up for LACP passive and a valid channels)
But can create 2x 8023ad 4Gb Etherchannels with no backups.... (2 Replies)