Assuming the printer is correctly configured (may not be the case... so try to telnet to the printer it should give you a prompt...) you can
L: is the numeric the value of the model e.g.r if memory serves me lj4x is 7...
Hello,
in hppi laserjet4 (net_lj4x) is 47.
BUT !
Newer low cost models like CLJ2605DN are not working with hppi (jetdirect). Set up has to be done as rprinter.
Regards
Last edited by bdittmar; 11-07-2008 at 12:04 PM..
Reason: Add
I am having trouble getting our accounting program (on SCO 5.05) to print to a shared windows printer. We used to use a program that took care of this PCI print server or somehting like that. but when XP service pack 2 got installed somethign happened with the permissions and the files would... (2 Replies)
I am attempting to setup an IP based printer in a SCO environment. It is a cognitive printer. I attempted to add it via the HP interface but I could not get anything sent from the spooler to the printer in SCO?
My questions is or are should this be setup as a local or remote printer? When I... (6 Replies)
Hi there,
I want to open a cash drawer remotely. The cash drawer is commanded by a printer.
I need to connect to the cash drawer which is connected over a network (and shared) and simply send a sequence of five ASCII commands (see http://pages.prodigy.net/daleharris/popopen2.htm) to a... (5 Replies)
Hi all;:)
I have the following strange problem with my network printer Hp Laser jet 4250n working with Hp9000 rp3410 Servers , it prints well under Microsoft windows operation system ,,, But under Hp Unix 11.1 applications such as text editor the printing font is very small (size 4) ;
one... (2 Replies)
I've looked around and am able to print landscape to a PCL 5 printer with this command:
lp -o landscape -o cpi=20 -o page-right=30 -o page-left=30
-d <printer> <file>.
Which gives me a nice 200 columns.
But, when I send the same output and the same commands to a PCL 6 printer, it comes... (3 Replies)
This is an easy one but have no clue how to start. I am connecting via a PC running XP using putty. I have a printer attached to my PC. I need to print stuff. How can I set up this printer?
Thanks !:eek:
---------- Post updated at 18:22 ---------- Previous update was at 16:38 ----------
The... (2 Replies)
We have a post script enabled printer setup. But when we send any .ps file using ps to this printer we are getting this error:
Cannot print postscript file because No postscript print queue exists for this printer.
Print queue name Xerox
Printer name... (0 Replies)
I am trying to get a network printer to work that currently works from my Unix (5.0.7) server when printing text files only. When I try to print post script files like a PDF file I get all of the controls so I am not sure if I have my printer configuration setup properly in Unix
The printer... (1 Reply)
I have been searching for a solution to a printing issue for several months now and have come up with no decently working solution. Please give input.
We have an old inventory control program running on TRU64 Unix V5.1B operating system. Around 2003 it was virtualized onto VMware via AVT's... (1 Reply)
Solaris 10:
Having some trouble with a new printer printing control codes. This is an HP MFP M632.
Tried a few ppd files and without a ppd file using commands similar to the follow:
lpadmin -p L4102A -v /dev/null -m netstandard -n... (1 Reply)