UBTBCMFW(4)						   BSD Kernel Interfaces Manual 					       UBTBCMFW(4)

NAME
ubtbcmfw -- Firmware driver for Broadcom BCM2033 chip based Bluetooth USB devices SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file: device ubtbcmfw Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): ubtbcmfw_load="YES" DESCRIPTION
The ubtbcmfw is a firmware driver for Broadcom BCM2033 chip based Bluetooth USB devices. It provides minimal access to the parts of the device required to download firmware. The ubtbcmfw driver creates three fixed endpoint device nodes. The control transfers can only happen on the control endpoint which is always endpoint 0. Control requests are issued by ioctl(2) calls. Only incoming transfers are supported on an interrupt endpoint. To perform I/O on an interrupt endpoint, read(2) should be used. All I/O operations on an interrupt endpoint are unbuffered. Interrupt endpoint is always endpoint 1. Only outgoing bulk transfers are supported on a bulk endpoint. To perform I/O on a bulk endpoint, write(2) should be used. All I/O opera- tions on a bulk endpoint are unbuffered. Outgoing bulk endpoint is always endpoint 2. The control endpoint (endpoint 0) handles the following ioctl(2) calls: USB_GET_DEVICE_DESC (usb_device_descriptor_t) Return the device descriptor. FILES
/dev/ubtbcmfwN.EE Endpoint EE of device N. SEE ALSO
ng_ubt(4), ugen(4), usb(4), bcmfw(8) HISTORY
The ubtbcmfw driver was implemented in FreeBSD 5.0. AUTHORS
Maksim Yevmenkin <m_evmenkin@yahoo.com> BUGS
Most likely. Please report if found. BSD
November 22, 2006 BSD