![]() |
|
|
|
|
|||||||
| Forums | Portal | Register | Rules & FAQ | Contribute | Members List | Arcade | Search | Today's Posts | Mark Forums Read |
| UNIX for Dummies Questions & Answers If you're not sure where to post a UNIX or Linux question, post it here. All UNIX and Linux newbies welcome !! |
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PCI / PCIExpress Parallel port in SCO 6.0.0 | uxlunatick | SCO | 2 | 04-18-2008 06:13 AM |
| Parallel port Printing in SCO OSR6 | Martyn | UNIX for Dummies Questions & Answers | 0 | 08-21-2006 07:31 AM |
| SCO openserver 6 parallel port issues | shuhemizer | UNIX for Advanced & Expert Users | 0 | 06-29-2006 12:51 PM |
| parallel port proramming for sun ultra | fishman2001 | High Level Programming | 2 | 10-23-2003 10:19 AM |
| Parallel Port info? | sajjan2 | Filesystems, Disks and Memory | 2 | 04-25-2002 05:35 PM |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
SCO openserver 6 parallel port issues
I am having issues with SCO recognizing my parallel port. The port is being used so I can run dialogic using a dongle for the serial number but the port is not noticed. It is turned on in the bios and should work fine but when I attempt to run the software I get errno=6 and it appears to not be there. I also attempted using mkdev but because its 6 its supposed to set itself up. I am running the same software on another computer and it works fine the only diffrence is the system I am using know is an ISA board this might also affect it but I don't know. Is there a way to configure the port to recognize the dongle? If anyone can offer any assistance I would be very greatful Thankyou.
|
|||
| Google UNIX.COM |
| Forum Sponsor | ||
|
|