Magneto-Optical drive for SCO Openserver 5.0.5

yurist · #1 (**permalink**) 02-27-2002

Hi,

I tried to install Magneto-Optical (MO) drive Fujutsu to COMPAQ Proliant ML350 with SCO Openserver 5.0.5. Harddisk and MO are connected to Adaptec UW-SCSI-3 (driver ad160).
During boot process system shows me that MO is connected to host adapter 1, bus 0, SCSI ID 1 and LUN 0. But when I tried use standard methods for installing it, such as mkdev hd, it is usually unsucsessful.

Who have any ideas about connecting Magneto-Optical drives for SCO Openserver?

Thanks

killerserv · #2 (**permalink**) 03-01-2002

You can see the configured disks on a SCO system by examining /etc/conf/cf.d/mscsi or "hwconfig | grep disk". Scsi devices may be probed with "sconf -v' . Else try mkdev hd_iiop

yurist · #3 (**permalink**) 03-01-2002

Could SCO Openserver work with block size 2048 on disk?

I have warning message that MO Disk has wrong block size 2048 bytes. When I tried to make filesystem on 230 Mb disk with block size 1024 bytes, operation was successful.

Have you any ideas about it?

Thank you for your advice.

More UNIX and Linux Forum Topics You Might Find Helpful
Thread	Thread Starter	Forum	Replies	Last Post
SCO Openserver Release 5 and HP VS160 Tape Drive	jfd7000	SCO	3	05-17-2008 01:52 PM
mounting USB floppy drive /Flash drive in OSR 6.0	sureshdrajan	SCO	5	02-29-2008 12:36 PM
Map Drive From Windows To Apache Shared Drive?	gseyforth	UNIX for Dummies Questions & Answers	0	02-23-2008 07:56 PM
Use dvdisaster to protect backups on optical media	iBot	UNIX and Linux RSS News	0	02-07-2008 05:50 AM
trying to set up an optical drive	kymberm	UNIX for Dummies Questions & Answers	1	07-21-2002 10:02 AM

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:


	Powered by