you can't see if it is correctly terminated... you have to check it's done! this is hardware. read here:
SCSI Termination Tutorial

Here is the output from cfgadm -a. As you can see c1 and c2 is the one installed.

cfgadm -a
Ap_Id                          Type         Receptacle   Occupant     Condition
c0                             scsi-bus     connected    configured   unknown
c0::dsk/c0t0d0                 disk         connected    configured   unknown
c0::dsk/c0t1d0                 disk         connected    configured   unknown
c0::dsk/c0t2d0                 CD-ROM       connected    configured   unknown
c1                             scsi-bus     connected    unconfigured unknown
c2                             scsi-bus     connected    unconfigured unknown
usb0/1                         usb-kbd      connected    configured   ok
usb0/2                         usb-mouse    connected    configured   ok
usb1/1                         unknown      empty        unconfigured ok
usb1/2                         unknown      empty        unconfigured ok
usb2/1                         unknown      empty        unconfigured ok
usb2/2                         unknown      empty        unconfigured ok
usb2/3                         unknown      empty        unconfigured ok
usb3/1                         unknown      empty        unconfigured ok
usb3/2                         unknown      empty        unconfigured ok
usb4/1                         unknown      empty        unconfigured ok
usb4/2                         unknown      empty        unconfigured ok
usb4/3                         unknown      empty        unconfigured ok
usb4/4                         usb-storage  connected    configured   ok
usb4/5                         usb-storage  connected    configured   ok

Hello,

Please use the below commnads and it's better to mention the Solaris version.

#devfsadm
#drvconfig

Thanks a lot guys.

When I try drvconfig comman it is trying to sync with array and getting the following error messages in the loop. Do you have any idea?


>got SCSI bus
> glm0: fault detected in device; service still available

---------- Post updated at 10:20 AM ---------- Previous update was at 08:39 AM ----------

Also, when I boot the server it is not loading. The following error message is comming.

>got SCSI bus
> glm0: fault detected in device; service still available

Any idea? Thanks in advance.

try to make a drawing of your setup... maybe we can find an error in your configuration.

Here is the setup.

In the D1000 ARRAY I have U cable connecting between SCSI A to SCSI B.

IN the boxes, both are connected to SCSI channel A.

Am I missing anything here? Thanks a lot all of you.