Solaris

Hello all,
I have a sun server SunOS PNR1RAD01 5.10 Generic_144488-09 sun4v sparc SUNW,Netra-T5220 where i have an interface e100g0.
This was earlier in running state but now this doesnt show running state. I tried to reset the interface, checked the cable but it did not help.
Can nyone pls help me on this.

e1000g0: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet 10.200.2.73 netmask fffffff8 broadcast 10.200.2.79
ether 0:21:28:bd:55:3e

What changes did you make to your system? Did you edit any files such as /etc/hostname.e1000g0?

nothing was done on the server,
but yes one observation, though it doesn't show running state but the ip defined on this interface is well reachable from another node. This eliminated my suspicion on the cable part. I also restarted the whole server as well but no luck.
Can someone advice further ??

Quote:

e1000g0: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet 10.200.2.73 netmask fffffff8 broadcast 10.200.2.79
ether 0:21:28:bd:55:3e

So what do you mean by not showing a "running state"?

Your quote above shows the interface as "up"

Your output shows its already up and running and you told ip is pingable then what else you are looking for?

If still any problem, just unplumb and plumb again and do all the configuration again.

see the other interface o/p:
ossuser@PNR1RAD01 # ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
e1000g0: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet 10.200.2.73 netmask fffffff8 broadcast 10.200.2.79
e1000g1: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 3
inet 10.200.3.58 netmask ffffffc0 broadcast 10.200.3.63

And one more observation:



root@PNR1RAD01 # dladm show-dev
e1000g0 link: down speed: 0 Mbps duplex: half
e1000g1 link: up speed: 1000 Mbps duplex: full
e1000g2 link: unknown speed: 0 Mbps duplex: half
e1000g3 link: unknown speed: 0 Mbps duplex: half

This link shows down in this command o/p although in ifconfig o/p it shows up but noot the running state as e1000g1 interface.

Please post output of:

Code:

 
cat /etc/hostname.e1000g0

and

Code:

 
cat /etc/hostname.e1000g1

Do the cables from e1000g0 and e1000g1 go to the same network switch?
If so, what make/model of switch? Does it understand multipaths?