SSL_connect(3) OpenSSL SSL_connect(3)
NAME
SSL_connect - initiate the TLS/SSL handshake with an TLS/SSL server
SYNOPSIS
#include <openssl/ssl.h>
int SSL_connect(SSL *ssl);
DESCRIPTION
SSL_connect() initiates the TLS/SSL handshake with a server. The communication channel must already have been set and assigned to the ssl
by setting an underlying BIO.
NOTES
The behaviour of SSL_connect() depends on the underlying BIO.
If the underlying BIO is blocking, SSL_connect() will only return once the handshake has been finished or an error occurred.
If the underlying BIO is non-blocking, SSL_connect() will also return when the underlying BIO could not satisfy the needs of SSL_connect()
to continue the handshake, indicating the problem by the return value -1. In this case a call to SSL_get_error() with the return value of
SSL_connect() will yield SSL_ERROR_WANT_READ or SSL_ERROR_WANT_WRITE. The calling process then must repeat the call after taking
appropriate action to satisfy the needs of SSL_connect(). The action depends on the underlying BIO. When using a non-blocking socket,
nothing is to be done, but select() can be used to check for the required condition. When using a buffering BIO, like a BIO pair, data must
be written into or retrieved out of the BIO before being able to continue.
RETURN VALUES
The following return values can occur:
1. The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been established.
2. The TLS/SSL handshake was not successful but was shut down controlled and by the specifications of the TLS/SSL protocol. Call
SSL_get_error() with the return value ret to find out the reason.
3. <0
The TLS/SSL handshake was not successful, because a fatal error occurred either at the protocol level or a connection failure occurred.
The shutdown was not clean. It can also occur of action is need to continue the operation for non-blocking BIOs. Call SSL_get_error()
with the return value ret to find out the reason.
SEE ALSO
SSL_get_error(3), SSL_accept(3), SSL_shutdown(3), ssl(3), bio(3), SSL_set_connect_state(3), SSL_do_handshake(3), SSL_CTX_new(3)
POD ERRORS
Hey! The above document had some coding errors, which are explained below:
Around line 49:
You have '=item 0' instead of the expected '=item 2'
Around line 55:
Expected '=item 3'
50 2013-03-05 SSL_connect(3)