fwip(4) [opensolaris man page]

FWIP(4) 						   BSD Kernel Interfaces Manual 						   FWIP(4)

NAME

     fwip -- IP over FireWire driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device firewire
	   device fwip

     Alternatively, to load the driver as a module at boot time, place the following lines in loader.conf(5):

	   firewire_load="YES"
	   if_fwip_load="YES"

DESCRIPTION

     The fwip driver provides standard IP over FireWire (IEEE 1394) based on the protocols described in RFC 2734 and RFC 3146.

     The firewire(4) and fwohci(4) drivers must be configured in the kernel as well.

     This driver supports polling(4) as well if it is compiled with the DEVICE_POLLING option.

SEE ALSO

     arp(4), firewire(4), fwe(4), fwohci(4), netintro(4), polling(4), ifconfig(8), kldload(8), sysctl(8)

HISTORY

     The fwip device driver first appeared in FreeBSD 5.3.

AUTHORS

     The fwip driver and this manual page were written by Doug Rabson, based on earlier work by Hidetoshi Shimokawa.

BUGS

     This driver currently does not support the MCAP protocol for multicast IP over FireWire.  Multicast packets are treated as broadcast packets
     which is sufficient for most trivial uses of multicast.

BSD
								   July 16, 2005							       BSD

FWOHCI(4)						   BSD Kernel Interfaces Manual 						 FWOHCI(4)

NAME

     fwohci -- OHCI FireWire chipset device driver

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel configuration file:

	   device firewire

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   firewire_load="YES"

     To disable physical access (see BUGS section for detail), put the following line in loader.conf(5):

	   hw.firewire.phydma_enable=0

HARDWARE

     The fwohci driver provides support for PCI/CardBus FireWire interface cards.  The driver supports the following IEEE 1394 OHCI chipsets:

     o	 Adaptec AHA-894x/AIC-5800
     o	 Apple Pangea
     o	 Apple UniNorth
     o	 Intel 82372FB
     o	 IOGEAR GUF320
     o	 Lucent / Agere FW322/323
     o	 NEC uPD72861
     o	 NEC uPD72870
     o	 NEC uPD72871/2
     o	 NEC uPD72873
     o	 NEC uPD72874
     o	 National Semiconductor CS4210
     o	 Ricoh R5C551
     o	 Ricoh R5C552
     o	 Sony CX3022
     o	 Sony i.LINK (CXD3222)
     o	 Sun PCIO-2 (RIO 1394)
     o	 Texas Instruments PCI4410A
     o	 Texas Instruments PCI4450
     o	 Texas Instruments PCI4451
     o	 Texas Instruments TSB12LV22
     o	 Texas Instruments TSB12LV23
     o	 Texas Instruments TSB12LV26
     o	 Texas Instruments TSB43AA22
     o	 Texas Instruments TSB43AB21/A/AI/A-EP
     o	 Texas Instruments TSB43AB22/A
     o	 Texas Instruments TSB43AB23
     o	 Texas Instruments TSB82AA2
     o	 VIA Fire II (VT6306)

SEE ALSO

     firewire(4), fwe(4), fwip(4), sbp(4), fwcontrol(8), kldload(8)

HISTORY

     The fwohci device driver first appeared in FreeBSD 5.0.

AUTHORS

     The fwohci device driver was written by Katsushi Kobayashi and Hidetoshi Shimokawa.

BUGS

     The driver allows physical access from any nodes on the bus by default.  This means that any devices on the bus can read and modify any mem-
     ory space which can be accessed by an IEEE 1394 OHCI chip.  It is allowed mostly for sbp(4) devices.  This should be changed to allow it only
     for specific devices.  Anyway, FireWire is a bus and not expected to be connected with un-trustable devices because a node can monitor all
     the traffic.

BSD
								   March 3, 2008							       BSD