dipole(1) [debian man page]

YAGI(1) 						      General Commands Manual							   YAGI(1)

NAME

       dipole - Yagi-Uda project file. Computez Z of a dipole

SYNOPSIS

       yagi [ - dhps ] filename

DESCRIPTION

       The  program  dipole  is  one  of  a number of executable programs that forms part of a set of programs, collectively known as the Yagi-Uda
       project , which were designed for analysis and optimisation of Yagi-Uda antennas.  dipole Was added to find the impedance of just a  single
       dipole.

SEE ALSO

       first(1), input(1), output(1), optimise(1), first(5), input(5), output(5) and optimise(5).

PLATFORMS

       Only UNIX versions have been produced. I can't be bothered with brain-dead operating systems like Windoze.

BUGS

       Bugs  should  be reported to david.kirkby@onetel.net.  Bugs tend actually to be fixed if they can be isolated, so it is in your interest to
       report them in such a way that they can be easily reproduced.  If the input file is edited manually and	done  incorrectly,  there  can	be
       unpredictable results.

AUTHORS

       Dr. David Kirkby G8WRB (david.kirkby@onetel.net), with help with converting to DOS from Dr. Joe Mack NA3T (mack@fcrfv2.ncifcrf.gov).

Version 1.16							24th October 2000							   YAGI(1)

INPUT(1)						      General Commands Manual							  INPUT(1)

NAME

       input - Yagi-Uda project antenna defining program

SYNOPSIS

       input [ - h ]

DESCRIPTION

       The  program  input  is	one  of  a  number of executable programs that forms part of a set of programs, collectively known as the Yagi-Uda
       project , which were designed for analysis and optimisation of Yagi-Uda antennas.  input is an interactive program, that asks the user  for
       information  about a Yagi design, such as position of elements, spacing between elements, frequency span of interest and a filename to save
       the data to.  input then writes this information into an ASCII file, which can be read by yagi or optimise The file is ASCII and it's  for-
       mat is easily understood by inspection (there are comments printed in it), so it can if necessary be edited manually.

       After  running  input and specifying a filename (for example 144e10) you should then type yagi 144e10 and then output 144e10 and optionally
       optimise 144e10

OPTIONS

       -h     Print a help message.

FILES

       filename 	ASCII data file in which design is put.

PLATFORMS

       Both DOS and Unix versions have been built. The DOS version as distributed requires a 386 PC with a 387 maths coprocessor.

AUTHORS

       Dr. David Kirkby G8WRB (david.kirkby@onetel.net).  with help with in converting to DOS/PC from Dr. Joe Mack NA3T (mack@fcrfv2.ncifcrf.gov)

SEE ALSO

       first(1), yagi(), output(1), optimise(1), input (5), first(5), yagi(5), output(5) and optimise(5).

       Bugs should be reported to
       david.kirkby@onetel.net.
       Bugs tend actually to be fixed if they can be isolated, so it is in your interest to report them in such a way  that  they  can	be  easily
       reproduced.

       If  a  mistake is made during inputting of data (such as entering an incorrect length), it is not possible to go back and correct this. You
       should make a note of the error, and edit the ASCII text file with a text editor (vi, DOS edit etc).

Version 1.16							24th October  2000							  INPUT(1)