DIFFIMG(1) General Commands Manual DIFFIMG(1)NAME
diffimg - Calculates intersection between two images
SYNOPSIS
diffimg image1 image2 [outimage]
DESCRIPTION
diffimg generates an image where each pixel is the difference between the corresponding pixel in each of the two source images. Thus, if
the source images are the same the resulting image will be black, otherwise it will have regions of non-black where the images differ.
Currently supports: .png, .gif, .jpg, and .ps by using ghostscript
AUTHOR
diffimg was written by John Ellson <ellson@research.att.com>
This manual page was written by David Claughton <dave@eclecticdave.com>, for the Debian project (but may be used by others).
Jan 31, 2010 DIFFIMG(1)
Check Out this Related Man Page
IDIFF(1) General Commands Manual IDIFF(1)NAME
idiff - compare two images
SYNOPSIS
idiff [options] image1 image2
DESCRIPTION
The idiff utility is invoked as follows:
idiff [options] image1 image2
Where input1 and input2 are the names of two image files that should be compared. They may be of any format recognized by OpenImageIO
(i.e., for which image-reading plugins are available).
If the two input images are not the same resolutions, or do not have the same number of channels, the comparison will return FAILURE imme-
diately and will not attempt to compare the pixels of the two images. If they are the same dimensions, the pixels of the two images will be
compared, and a report will be printed including the mean and maximum error, how many pixels were above the warning and failure thresholds,
and whether the result is PASS, WARNING, or FAILURE. For example:
$ idiff a.jpg b.jpg
Comparing "a.jpg" and "b.jpg"
Mean error = 0.00450079
RMS error = 0.00764215
Peak SNR = 42.3357
Max error = 0.254902 @ (700, 222, B)
574062 pixels (82.1%) over 1e-06
574062 pixels (82.1%) over 1e-06
FAILURE
The "mean error" is the average difference (per channel, per pixel). The "max error" is the largest difference in any pixel channel, and
will point out on which pixel and channel it was found. It will also give a count of how many pixels were above the warning and failure
thresholds.
The metadata of the two images (e.g., the comments) are not currently compared; only differences in pixel values are taken into considera-
tion.
For a complete description, see /usr/share/doc/libopenimageio-dev/openimageio.pdf.gz.
OPTIONS --help Print help message
-v Verbose status messages
-a Compare all subimages/miplevels
Thresholding and comparison options
-fail %g
Failure threshold difference (0.000001)
-failpercent %g
Allow this percentage of failures (0)
-hardfail %g
Fail if any one pixel exceeds this error (infinity)
-warn %g
Warning threshold difference (0.00001)
-warnpercent %g
Allow this percentage of warnings (0)
-hardwarn %g
Warn if any one pixel exceeds this error (infinity)
-p Perform perceptual (rather than numeric) comparison
Difference image options
-o %s Output difference image
-od Output image only if nonzero difference
-abs Output image of absolute value, not signed difference
-scale %g
Scale the output image by this factor
SEE ALSO iconvert(1), igrep(1), iinfo(1), iprocess(1), iv(1), maketx(1), oiiotool(1).
AUTHOR
OpenImageIO was written by Larry Gritz and the other authors and contributors.
This manual page was written by IRIE Shinsuke <irieshinsuke@yahoo.co.jp>, for the Debian project (and may be used by others).
May 19, 2012 IDIFF(1)