How to determine if there is a Power Problem using DIAG command?

sky_lark02 · #1 (**permalink**) 03-11-2008

Hi guys can someone show me on how to use DIAG command in determining if there is really a power problem aside from errpt report?

dukessd · #2 (**permalink**) 03-11-2008

diag
advanced diags
system verification
highlight sysplanar0
enter to select it
f7 to run the diags.

Read the output with care, it can be confusing if you already have errpt entries for a power problem.

If you use diags, task selection, log a repair to sysplanar0 before you begin then the diags in system verification will ignore the errpt entries logged before the repair action was logged and just test the system and let you know if a problem was found.

sky_lark02 · #3 (**permalink**) 03-18-2008

Thanks Duke

More UNIX and Linux Forum Topics You Might Find Helpful
Thread	Thread Starter	Forum	Replies	Last Post
No Power Struggles: Coordinated Multilevel Power Management for the Data Center	iBot	UNIX and Linux RSS News	0	12-24-2007 05:20 AM
Booting up problem after power outage	lungsta	SUN Solaris	2	02-21-2007 06:00 PM
What's meaning of "POWER" in diag command.?	pattarapongn	AIX	1	09-24-2006 06:57 PM
Command to determine Tape Drive model and make	new2prog	SUN Solaris	5	01-06-2006 04:17 PM
Command to determine Tape Type	Surdeymon	AIX	4	06-10-2005 01:19 PM

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:


	Powered by