IBM's pSeries 570 vs a 520 vs 550 Post: 302751345

9 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Help with IBM 550 and HMC settings

I'm a Solaris and Debian/SuSE weenie, and I need some help setting the IP address of the remote web interface on an IBM 550 I plugged the port labled HMC1 to the network. The "network" is really a small linksys router that I use to test internet configs, as I can change the settings at will...

2. AIX

new IBM pseries and new disks

Hello Gurus, i'm quite new person in AIX world, actually i'm SAP consultant. But due to my job faced with AIX. Trying to configure new server for installation SAP. We have 4 disks one of them (hdisk3) has VG rootvg. How i can extend rootvg with another disk? i tried: # extendvg rootvg hdisk0...

3. Linux

Why does they use Linux on IBM pSeries

Anyone can help me answer the question. Why does they use Linux on IBM pSeries not AIX. I can't understand why, cause AIX is the best supporting from IBM pSeries. Tks you.

4. AIX

p6 570 network for AIX LPAR

know how to do it.

5. AIX

IBM pSeries Power5 9111-285 1,9 GHz

Hi , I am planing to buy IBM pSeries Power5 9111-285 1,9 GHz but I am confused with few things. I would be happy if you could clear it up for me ? 1.Do I have to buy some license in order to create Lpars ? 2.Do I have to buy some license in order to use HMC , micro - partiocioning , VIOS...

6. Hardware

VT 520 Terminal

Back of a VT 520 Teminal has a 1"X1" (approx.) rectangular area covered by a removable plastic flap. It is just above the keyboard hole(mini 6 pin DIN). What is it? Thank you. ---------- Post updated at 02:49 PM ---------- Previous update was at 11:37 AM ---------- I've got the answer....

7. AIX

IBM Power Pseries Open Firmware boot / VIOS POWERVM VET CODE

Hello, I installed PowerVM IVM Virtual I/O on P-550 but later found out that the machine isn't activated for CoD VET code for virtualization. So when booted , it goes into OPEN Firmware I/O Hosting requires a hosting partition boot not permitted exit called > ok Panel shows > IO...

8. AIX

IBM QSECOFR password missing P/N 9405-520

How to remove or reset password QSECOFR from IBM iSeries AS/400 P/N 9405-520. Regards

9. AIX

IBM AIX console pseries

Hi, when I boot I get an E1DC error code. I've looked it up and it says that this error occurs during the firmware check. But the error is called "Dynamic Console Selection" . 1- Machine stopped at LCD led display = E1DC = CA00E1DC E1DC Dynamic console selection. (maybe cable or keyboard)...

LEARN ABOUT NETBSD

tr

TR(4)							   BSD Kernel Interfaces Manual 						     TR(4)

NAME

     tr -- TROPIC based shared memory Token-Ring cards device driver

SYNOPSIS

     tr0 at isa? port 0xa20 iomem 0xd800 irq ?
     tr* at isa? port ? irq ?
     tr* at isapnp?
     tr* at mca? slot ?
     tr* at pcmcia? function ?

DESCRIPTION

     The tr device driver supports TROPIC I based shared-memory Token-Ring cards.

HARDWARE

     Supported cards include the following IBM and 3Com models:

	   IBM	 Token-Ring Network PC Adapter

	   IBM	 Token-Ring Network PC Adapter II

	   IBM	 Token-Ring Network Adapter/A

	   IBM	 Token-Ring Network 16/4 Adapter

	   IBM	 Token-Ring Network 16/4 Adapter/A

	   IBM	 Token-Ring 16/4 Credit Card Adapter

	   IBM	 Token Ring Auto 16/4 Credit Card Adapter

	   IBM	 Turbo 16/4 Token Ring PC Card

	   IBM	 16/4 ISA Adapter

	   IBM	 Auto 16/4 Token-Ring ISA Adapter

	   IBM	 Token Ring 16/4 Credit Card Adapter

	   IBM	 Token Ring Auto 16/4 Credit Card Adapter

	   IBM	 Turbo 16/4 Token Ring PC Card

	   3Com  3C619 TokenLink

	   3Com  3C319 TokenLink Velocity

	   3Com  3C389 TokenLink Velocity PC Card

SOURCE ROUTING

     Setting IFF_LINK0 enables Token-Ring source routing.  Setting IFF_LINK1 uses all-routes broadcasts otherwise single-route broadcasts are
     used.

NOTES

     The MCA attachment has been only tested on IBM Token Ring 16/4 Adapter/A so far.  It doesn't support ifmedia(4) yet, too.

SEE ALSO

     ifmedia(4), intro(4), isa(4), isapnp(4), mca(4), pcmcia(4), ifconfig(8)

HISTORY

     The tr driver appeared in NetBSD 1.4.

BUGS

     The PCMCIA attachment does not work with the cbb(4) CardBus driver.

BSD
								  April 14, 1999							       BSD