Login or Register to Ask a Question and Join Our Community

Sponsored Content
Full Discussion: Problems with network card in SCO
Operating Systems SCO Problems with network card in SCO Post 302380904 by daniel_cie on Wednesday 16th of December 2009 02:55:02 PM
Old 12-16-2009
Problems with network card in SCO
hello, i am new to unix and need support</SPAN></SPAN>
</SPAN></SPAN>The problem is:
I have a SCO 5.0.5 server, and has no local network access, I think my problem are the drivers for network card.
my network card is Kingston EtheRx PCI Fast Ethernet Adapter KNE120TX and already installed the drivers, but when I run:
# hwconfig-h the result that describes the network card is:
ktcHT 0xd400-0xd41f - - Kingston Et ....... NOT FOUND [KNE120TX]

reinstall the drivers and the network connection, but does not work
when setting up the network connection, save with default values:
Bus = 0
Device = 0
Function = 0
this can cause any conflict?
if this is wrong, what are the correct values?
 

10 More Discussions You Might Find Interesting

1. IP Networking

network card

I have a UnixWare 2 server that has an ISA 3Com NIC that has just a BNC connector on it. I want to remove this and install an ISA 3Com NIC that has a BNC/RJ45 connector. What steps do I have to go through to successfully complete this? Thye are almost the exact same cards except for the... (1 Reply)
Discussion started by: cparks
1 Replies

2. IP Networking

Network Card with SGI

The Octane is driving me nuts . It was sitting on the network doing its job nicely and i had to pull the n/w cable out from the wall to pull it from the inside of the table and connected it again . The logs show this -- link down .... < when i pulled it out > link ok < when i connected > But... (0 Replies)
Discussion started by: DPAI
0 Replies

3. UNIX for Advanced & Expert Users

Network Card Help

I have been having trouble with my sis900 neytwork card in slacwkare linux. I tried to modprobe the sis900, it didnt give me any errors but it didnt load it. so I put in a realtek 8139 network card and tried it too. These are the errors i get with the two cards when trying to do insmod on either of... (3 Replies)
Discussion started by: The Fridgerator
3 Replies

4. UNIX for Dummies Questions & Answers

Network card and internet

Hi!. I have problems installing my network card under ther redhat kernel. First i tryed my integrated intel pro set 10/100 then my d-link 530tx Pci but none of them seems to be found. also i huse my network card to connect to the net trough PPPOE where i need to type my username and... (3 Replies)
Discussion started by: Gibbler
3 Replies

5. SCO

3c905b network card problem with SCO 5.0.5

Hi, I was wondering if anyone could help me out with this problem. I have SCO 5.0.5 installed on a system that I am using 3c905b (3 Com) network card. This system is always powered on. After no certain time period this NIC doesn't work. I can't ping to this system from any other machine or vice... (2 Replies)
Discussion started by: AtALoss
2 Replies

6. UNIX for Dummies Questions & Answers

How can I tell which network card is which?

I have three network cards in my unix box. I need to figure out which card corresponds to an assigned IP address. If there some command in unix I can use to make an ethernet interface blink? Any advice would be appreciated. (6 Replies)
Discussion started by: mojoman
6 Replies

7. Solaris

How to identifying the network card ?

Hi Experts, Can we use some command from unix to find the available network interface? I did tried Its listing following, however how can I decide the which vender card is attached e.g. if its hme , bge or some thing else Thanks (7 Replies)
Discussion started by: kumarmani
7 Replies

8. SCO

network problems with sco

SCO unix 5.0.5 - Suddently network lost & has to be reboot. I try to stop TCP & start TCP. but no connection. Any idea about that. thanks (8 Replies)
Discussion started by: ajantha
8 Replies

9. Solaris

Network Card Name details

Hi All, Can somebody explain that whats the meaning of different interfaces naming scheme, Like ' hme, qfe, e1000g0, ce, eri, bge' ? This is such a basic question which i always overlooked :( Thanks ! (6 Replies)
Discussion started by: Solarister
6 Replies

10. Red Hat

Regarding Network Interface Card

Dear All , While taking backups in one Linux Server , we find one alert came with regard to Network Interface Card. Pl find the below alert. Network Interface Card performance for NIC:eth1 has exceeded Major threshold. Bytes sent and received per second (Average)= 105540.303101... (6 Replies)
Discussion started by: jegaraman
6 Replies

LEARN ABOUT DEBIAN

mdbfontsize

mdbFontSize(5)							 The m17n Library						    mdbFontSize(5)

NAME

       mdbFontSize - Font Size

DESCRIPTION

       In some case, a font contains incorrect information about its size (typically in the case of a hacked TrueType font), which results in a
       bad text layout when such a font is used in combination with the other fonts. To overcome this problem, the m17n library loads information
       about font-size adjustment from the m17n database by the tags <font, resize>. The data is loaded as a plist of this format.

       FONT-SIZE-ADJUSTMENT ::= PER-FONT *

       PER-FONT ::= '(' FONT-SPEC ADJUST-RATIO ')'

       FONT-SPEC ::=
	   '(' [ FOUNDRY FAMILY
	      [ WEIGHT [ STYLE [ STRETCH [ ADSTYLE ]]]]]
	    REGISTRY ')'

       ADJUST-RATIO ::= INTEGER

       FONT-SPEC is to specify properties of a font. FOUNDRY to REGISTRY are symbols corresponding to Mfoundry to Mregistry property of a font.
       See m17nFont for the meaning of each property.

       ADJUST-RATIO is an integer number specifying by percentage how much the font-size must be adjusted. For instance, this PER-FONT:

	   ((devanagari-cdac) 150)

       instructs the font handler of the m17n library to open a font of 1.5 times bigger than a requested size on opening a font whose registry is
       'devanagari-cdac'.

COPYRIGHT

       Copyright (C) 2001 Information-technology Promotion Agency (IPA)
       Copyright (C) 2001-2011 National Institute of Advanced Industrial Science and Technology (AIST)
       Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License
       <http://www.gnu.org/licenses/fdl.html>.

Version 1.6.2							    12 Jan 2011 						    mdbFontSize(5)
All times are GMT -4. The time now is 05:46 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy